Speed Passion Reventon-R - changing profiles
 

Hello all, I was just wondering if someone might be able to help me. I've just bought a Speed Passion Reventon-R and I've been trying to get it set up ready for my hpi cup racer project. As out of the box it has the nd1 profile installed which gives forward and brake but no reverse. Is there any easy way to change the profile without connecting to a pc? I've had a read through the manual but can't seem to find anything. I was hoping I'd be able to switch profiles using the included programme card, but it only seems to allow you to change parameters but not profile?

Has anyone found a simple solution to this?

Thanks in advance,
Oliver

Keep going through the options on the programming card and I think the last one allows you to changes the profile. You should ses 'nd1' on the programming card, just change the value..

I've tried that, but it didn't allow it to be changed. In the end, after a lot of faffing around, I managed to change it in the software. I found you needed to have the battery connected as it would be in the car, and then switch on and plugged into the computer, but it did seem to crash a lot!

all speed passions are similar
of course you have to have battery pluged in and switched on
all must be wired up first
proggy box to speedo = change settings
proggy box to pc/lappy and esc = to change profiles