Sanwa 451 aerial repair
 

I've found my sanwa 451 reciever aerial broken and it's broken near the case, so prob about 3 - 4cm on the wire.

So two questions:

1) How much of an issue is this going to be on a 1/10th track?
2) Any suggestions for who can repair these RXs?

Mike

If it's just the aerial just replace it open the case there not soldered in just clips on to the board aerials only about £5

Ah ok, cheers I'll have to find out who sells them and hope I can get one for the TORCH GP.

This
http://www.modelsport.co.uk/hpi-2.4g...products/36801

or this should do the job http://demonpowerproducts.co.uk/prod...a-sanwa-p-6473

I have the Zeppin one works fine

Cheers,

Also found this - http://www.apexmodels.com/gbu0-prods...07A41101A.html

Will contact shops on Monday.

Mike