RB6 rear arms on FS2
 

Anyone tried these as I understand they are similar to NCG arms?

Pretty certain saw them on Kev's car at TORCH

i asked the same thing but never got a response. :(

http://www.oople.com/forums/showpost...1&postcount=30

Yes it can be done, you need the outer hinge pins too UM561 (about £10 a pair!!) I think.

You will need the 2mm spacers between the RF / LAW36 hinge pin block and the new wishbones.

If your already have the LAW43 parts there is no benefit from doing this (other than common spares with the RB6 of course ... but you still need to by Lazer arms to get the fronts!)