Bone popping out of outdrive on X-6
 

Ok, the situation as stands:

3mm of limiters in shockers
3 shims on each CVD axle
-2* camber
inside hole on wishbones, 3rd in on tower

The bones is hanging out of the outdrive, i want to run -1* camber but it just pops out.

What do i do? :confused:

Have you got the BK2 CVD axles fitted, these will cure it if not.....

No i havent, its just standard kit + FT B4

BTW, thanks for geting it to me so quick :thumbsup: i might be ringing you later on about some spares.

shim it out some more to stop it happening with the kit cvd's

think I may have 8mm or more in mine

Darren

list the parts for the BK2 conversion please

I would but i dont have any shims left :p oh and i found a full set of your anti-squat shimz in the box of tricks i bought off James Shanley.

u need the bk2 axles really, but i re drill of the drive shaft will help in the mean time, never don't it myself but I'm sure someone will tell you how fare out you need to come,2-3mm is my guess.

there no use inside the shocks :p

If i put one in the shocks it might stop the bones popping out though :p

dont worry i wont. I need more shims :cry: wonder if DMS have any......

re-drill the B4 kit axles for the drive pin so that you shim the axle inwards in the upright?

I think its something like that, but i dont have a pedstle drill so ill get the BK2 axles.

Is this the part number for the shims AS31162?

just use any spacer josh, thats all i did.

If you ask rich lowe how many i had in my shocks at the clash he will tell you it was about 14 mm.

Eventually i realised i was using xx4 rear shocks :lol:

If gone through every box i have, i dont have anymore spacers. I have the big ones that go between the bearings in the hubs but thats to much, iv checked.

hmmm, im sure we can sort something for you, just use all the pistons you are not currently using:lol:

how can you not have any shocks spacers? go raid your house :lol: you got any of the red rubber shocks seals?

If you are desperate then strip a bit of insulation from some motor wire and cut to length :thumbsup:

woah woah woah, crossed lines here badly. Im talking about shims on the axle :lol: iv got loads of stuff that'll go in the shocks.

maybe 1mm more in the shocks will do the trick then ;)

just buy the bk2 axels it will save you all this hassle :lol:

I was thinking along those lines :lol: