Speed passion GT 2.0
 

Has any of you helpful chaps got a setup for outdoor with this speedo, just got the pro programing card and hoping to use boost timing etc, but not a clue where to begin. Im running the thunder power 8.5 turn motor and currently got the 428MOD software on the ESC. Cheers :)

Damo, please do not take offence from this but if you require help with specific car setup, speedo setup etc please use the regular forum in the electronics, Schumacher section etc. The moderators are not fond of people discussing these matters on club sub sections as asking on the main forum means more accessability for people with similar issues.

I used to run at GT2.0 and found punch level 3-4 a good place to start with a 2wd but you will need to ask elsewhere for more info. Post in the electrics section you will receive plenty of good advice there.


Chris

Is it the pro or lpf version? You want the lowest punch setting

lowest punch no booost unless you like putting out fires

Chris I've got one of these speedos but the programme box I've got dosnt work it have you got the LCD programme box? Tried doing it using the button but its far to stressful to do owt!

Boosted is fine, bud, get the hobby wing LCD programming box from giantshark.com for a tenner. It works with speed passion and is £30 cheaper tan the speed passion one

Will this be able to download the latest software onto an SP GT2.0 Pro aswell ???

cheers

Cheers gav

Yep and will also let you use the turbo (if you have the pro version)

Of course it's the pro version thats the beauty of being sponsered !

Was meaning damo there bud.

Only problem is I'm sponsered by rc scrap

http://i1206.photobucket.com/albums/...ps142c9f53.jpg

That's the program card but when I plug it in it just lights up with some red dashes

Yeah it's crap get the LCD one

sp program box
 

I've got one, it works perfectly, I'll take it to the track tomorrow.

Cheers Millsy see you tomorrow

They work but you need the book to tell you what each number means

Daft question but have you tried both ports for the programming cable as I had the same issue and when I tried the second one I was able to read and change the settings.

Showing the programming box in front of a Salford Uni brochure isn't going to fool anyone into thinking you are educated Buds.....