Receiver wire
 

All

Just after some advice. My receiver wire is completely frayed about half way up the wire. I have another receiver that doesn't work but the wire is perfect. Sorry for basic question but can I repair by cutting good wire from other receiver and putting onto the working receiver

what reciever model and make is it.
i had a ko and sanwa 2.4 handsets and you cannot just attach a bit of extra wire you need to replace the wire completely. The wire had a small clip that connects to the main board no soldering required. Older handsets you could have soldered in a new wire , depends what u have.

Hi

It's a etronix pulse 3-ch 2.4ghz. I have opened up and can see that the wires is soldered into the board so I am guessing I could take old one out and solder new one in?

Thanks for ur help

Yeah that will be fine swapping them over

Went to put the wire into the aerial and as I thought may happen, the wire snapped half way. I moved the receiver nearer the aerial part and run the wire half way up the aerial. Sorry for a basic question but when I try the car, it is great within about 10 metres distance, any further and I lose total control. I.e. I would make it fully around track.

Is there anything specific at the end of the wire to give signal. I have tried taking shell off and plastic aerial so just wire in car and get the same problem.

Help, been trying to get this sorted all day.....