Lrp Sxx tc v2 help please
 

Hi all,

Put my lrp Sxx tc v2 in my t4 today. It is starting and stopping very quickly. Can't even use it. I've checked the manual and its next to useless!
Has anyone had any experience with them?
Do I need to plug it into a lrp interface into the laptop and reset it? Or is there a process of pressing buttons I can do?
I have a 15.5t sensors motor in it so that's not a problem.
Any help would be great on this matter! It's very frustrating!

Thanks in advance all

did you reset the end points for trottle brake and neutral?

Yea I've tried using the setup on the manual to reset it all

So you have done this bit from the manual below or reset the different settings for boost etc


http://www.oople.com/forums/attachme...1&d=1375648091

Yep that's what I have done. Didn't make a difference

My servo is now giving me problems! It goes straight to full lock... What a pain in the ass! It can't be a tx issue as my tx works fine on my other car...

what about turning the brake percentage down on Tx. I know from previous LRP esc it can be strong on brakes maybe this would help.

Thanks for the advice! Turns out I have a nackered board :-(