Multiplate Slipper for TM2
 

The HBI slipper shaft that enables the excellent Schelle Nova slipper to be fitted to the TM2 has come through its first day of racing at TORCH with flying colours!

It was reported that: "Slipper performed perfectly. It's setting didn't change all day. No play at all so I'm sure flats are holding up.The slipper was really cool too https://www.facebook.com/images/emoj...1/16/1f642.png Maybe only 30 degrees."

During installation it was also possible to compare the weight of the HBI/Schelle unit with that of the standard assembly, as shown on the attached photo.

Schelle Slipper

Attachment 93493

Plus HBI shaft

Attachment 93494

Much smoother and consistent compared to original

Attachment 93496

Tm4 slipper fitment
 

Hi.

Sorry to hijack this thread but can this be modified to fit in the tm4te?

I currrently have the centre diff which comes standard with the team edition tm4. I'd like the option of dropping in a slipper clutch without having to change the top decks mid shafts and reposition the motor mount. Anybody done this?

http://i146.photobucket.com/albums/r...psqp7f3tay.jpg

It looks as though there may be enough room between the bearings but the orange plate would probably need to be replaced. It wouldn't be exactly the same as the TM2 solution and I would need a shed load of parts to measure up before I could say for sure.

The xray xb4 slipper is a straight swap with the tm4 centre diff

Thanks Joel. Does it work OK and stay constant over the day?

Works great, very consistent and plenty of adjustment

serpent 2wd slipper fits!!!!:thumbsup: