![]() |
sx motor tighting
Hi all iam being thick,,,,but how do you tighten the motor up in the sx,just got mine today but no manual ect.
Thanks leon |
under the under tray theres a gap in the carbon fiber,inside that theres a 2.5mm screw that closes the motor clamp on to the motor,crank it up nice and tight, and make sure its not on a sticker and make sure its square before you tighten it up,
|
You'll need to take the undertray off if fitted, and there's a screw that you access through the underside of the chassis.
|
sx
Hi guys thanks for that lol
other thing any pics of how do you get the positive wire to the lipo? leon |
No pic at the mo. But I cable tied mine underneath the top deck using the two holes towards the rear. Don't know if this is how Schumacher intended, but the holes seem extremely useful.
Also, make sure the top deck is fitted with these two holes closest to the belt / Battery side. This will ensure the wire is supported very near to the belt and bang on inbetween the upper and lower run, so should never touch. |
lipo
yea i was looking at that going to give it a go.
cheers |
3 Attachment(s)
thats exactly how we do matty's
|
sx
Hi thanks for those will try it,ive just had it out and flies but lipo seems to move about to much so muchit took off the top belt???.
Thanksfor all the help,great car tho leon |
u need the lipo retainer
|
hi ok will look for one,thanks
|
atomic carbon clicky
|
awsome thanks
|
you can download a manual from schumachers site also, will help you for future reference with maintenance etc, part numbers
|
| All times are GMT. The time now is 07:23 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
oOple.com