Xray T2009 driveshaft and steering block problem
 

Hey guys

Ive been having trouble since the start of the carpet season with my driveshafts and steering block on my XRAY T2009.

The coupling that goes inside the driveshaft that holds the pins keeps locking up, causing stiff steering as coupling cannot move very well. I have changed nothing on these before the carpet season.

The steering block keeps stripping on the hold where the steering arms where front toe is ajusted goes into, i am being careful to leave it slack and stop tightening when it nips the plastic, the only thing i have changed on these is put a 2mm shim onto the arms which screw into the steering block, do i need a slightly longer screw?

Sorry for the long post but answers to my problems would really help, it is getting very frustrating and expensive doing this.

thank you.

Problem now solved thanks to member of another forum.

Don't tell us how you fixed it then.....:p

Cause was probably that much embatrasing that he doesn't want to tell :p

All the more reason to find out!

Apparently the washer is to big on my front toe links though this is Graham Kennys set-up...

as of driveshaft, replace barrel and pin and give a good clean i was told, hope this works.

getting frustrating :lol:

Truly this never happened to me on any of Xray cars I had (T1 FK04, T2, 007, 008 and 009), but it should help.

I had the 007 and never had this problem and never had this problem on the 009 until now, really strange

Calvin....you need to start sitting beside the "grown-up" again.....this never happened when I sat in the creche.....lol

ill be early this time ;)

Really wanna make a b final next week, will hopefully be quiet as its sunday not saturday. Though the B can be very rough it reminds me of the time i went to banger racing :lol: