GM 120 Issue - Cogging
 

Hi All, nothing is ever simple in this hobby!

Having a few issues with the above speedo. On firmware 7.2 and model 7168. I am having cogging issues at low speed when running sensored.

I set the speedo to program 2 via the transmitter and reset mode 2 as well. I have used a laptop and played around with soft start and turning amps down, but nothing seems to help. If i unplug the sensor lead things get worse.

I am using a futaba 3vc handset with throttle reversed and everything set to 100. I am using a brand new 6.5 gm motor (tried a losi 6.5 as well with the same issues)

I am a little worried the speedo is faulty, any ideas? Is there a setting i have missed?

I also set to LIPO mode, but this didn't help either :(
Thanks

Dave

try a new gm sensor wire

tried several :(

Have you tried cleaning up the sensor area inside the motor?

Motor is brand new, and tried another motor with same results. Feels like a setting is wrong or something

try reflashing the esc with the latest firmware, reset esc and try mode 2

Don't think i can reflash software as not a 2010 model. I will try a factory reset though. Do you know how to do that?

I have made progress, we chose mode 8 and this was loads better, and ballistic with a 6.5 motor! We also tried a power cap in my spektrum reciever which seemed to help as well. Nearly there now.....

oh yep sorry, forgot it wasnt 2010 model. I was about to tell you to post on the GM forum, but I think you already have. Dont know how to factory reset your one

yeah i have, think i know how know, hold the set button. Will give it a go later