Proline Bulldog on B44?
 

Just a quick question, does the Proline Bulldog fit the B44 chassis?

Or is it only B44.1??

you would need to trim a few mm off the front sides of the chassis to make it fit.

Cheers for that, if its not too much chassis material to remove I may have a go, or buy the 44.1 chassis but I think this is about £50 ish so dremel time!

I did mine to fit a punisher shell.

Had to trim the front, move the servo inboard a few mm and reposition the aerial mount.

i fitted a bulldog shell to mine no problems just got hacksaw and a file to trim front part of chassis, just cut it back as far as the under tray screw holes (about 2.5-3mm off). took me about 10mins to do didnt need to strip car down or pull electrics out. :thumbsup:

I fitted a bulldog.... Oh, no, wait, I didn't cos it's chuffin ugly!

there will be a bit of a gap from the chassis to the body

says the guy who is blind loooooooooooooool

why in gods name would you what to run the ugliest body ever made ....
i dont know what all the fuss is about these forward cab bodies ....
they dont work very well! and only seem to work on a point and shoot track!!!!:thumbdown::thumbdown:

pitty Roar didnt get their way and band them!!!:thumbdown:
get rid of them they are S#$T!!!!:thumbsup:
FOLLOW THE LEADER is wat every one is doing!!!
if u like them yourll like these then!!

I was expecting all the cab forward manufacturers to issue a press release today and apologise for their early april fools joke being taken seriously by everyone

Am I? Prehaps I should tell my insurance company...

Got the bulldog on my 44, mainly because everyone hates it.. :woot: