sp to vega
 

Hi,im sorry as i know this has been asked before,the only think is its not to clear,
iv got a bit of a mission,i need to know all the parts needed to get an sp that i pick up friday to be running as a vega on sunday,so i need to order all the parts asap,,
thanks
Mark

You will need SP2 layshaft and also i think the rear wishbones are the longer ones.We also run the 1 Degree rear alloy hubs.Are you at bridgeford on sunday will see ya there.

thanks Andrew,i really need to know all part numbers and to be sure i get everything i need in one order,is it also worth getting anything in with the vega order,i will we there if i get it built:thumbsup:

Think i have got spare layshaft out of the car i brought of smithy the other week.If you need one for the week end.I think JE spares stock them.

I got a ropey rb5 that I have thought about converting. Don't believe it's a sp though

thanks Andrew,i might take you up on that offer,at this rate i will need to borrow his car:lol:

You wont need the wishbones... SP will be fine...

SP wishbones (UM521) same length but with 2 holes for securing the shock bottom.

SP2 wishbones (UM521-1) same length as above but only 1 fixing hole for shock bottom.

UMW516-1 are the 1 deg ally hubs

UMW514 Rear Front WIDE hingepin holder
UMW515 Rear Rear WIDE hingepin holder

UM524 Extended Main Shaft (Layshaft)

HTH

:thumbsup:

Thanks njc11,iv looked on je spares and they only have 515 but not 514,does it come under another number as it seems odd that it would say 515 wide rear hinge pin holder but then not have the other part,
thanks
Mark

Hi,if i get an sp1 do i still need the hinge pin hangers and layshaft?......also what lb springs should i get and what brand oils are the team using,also will i get the long hingepin holders in with this UMW505B,
thanks
Mark

Hi,thinking of doing the same conversion but i have an sp with the long top shaft and motor spacer,do i really need the alloy hinge pin holders as mentioned to complete the convesion as they seem rarer than rocking horse poo?:)

the sp2 comes with the wide plastic/carbon ones in the kit,i dont know what the sp comes fitted with,if they are the narrow ones you will need to to shave eather some off the arms on the inside as they will rub on the chassis so much the arms dont move up ur down,you could shave some off the chassis to get the same effect,the other thing iv noticed with the kit ones(wide)is they arnt very strong and bow quite easy,iv broken the rear front one,admittedly from hitting the climbing frame in the garden:woot:......so you dont realy need them but i would and will br getting them,jespares have the rear rear but i cant find the front rear,
hope this helps

SP came with the wide hangers too ... would just need the layshaft I beleive.

As for the hinge pin holders nobody seems to have told JE Spares they are hard to get, a quick phone call and postie showed up with some!