oOple.com Forums

oOple.com Forums (http://www.oople.com/forums/index.php)
-   Electrics (http://www.oople.com/forums/forumdisplay.php?f=26)
-   -   Lipo cut off module? (http://www.oople.com/forums/showthread.php?t=75586)

kaszal 17-07-2011 04:38 PM

Lipo cut off module?
 
I'm running an old Novak GTB without the Lipo low voltage cut-off circuitry. I want to run 7.4v Lipo with a 5.5T motor and was wondering what's the easiest solution? I doubt I'd need it with a 4000mAh Lipo in a 5 min race but maybe there's a danger if I overun in practice.

This one is cheap and from a UK supplier. Is it good?

http://cgi.ebay.co.uk/JP-LI-PO-LI-PO...item4cf0297536

Sorry if there's a thread already... "Lipo low voltage cut off" are common words!

kaszal 17-07-2011 04:47 PM

This one has a buzzer...

http://cgi.ebay.co.uk/JP-LIPO-LOW-VO...item588e5e380a

bodgit 17-07-2011 04:54 PM

I have the same esc in one of my cars and use a novak smart stop. Those two you show are cheap but rely on you seeingand hearing the warnings and stopping yourself before your lipovoltage drops too low. The smart stop is more expensive but stops the car automatically eliminating you needing to pay attention.
Try an advert in the wanted section.

kaszal 17-07-2011 05:07 PM

Thank you. Is is complicated or untidy to install?

VintageRacer 17-07-2011 05:50 PM

Not complicated, a few extra bits of wire around, but easy enough to tidy up.

You have solder a positive and negative wire to the battery or ESC battery input positive and negative, then the Smart Stop plugs into the receiver and the ESC plugs into the smart stop.

VintageRacer 18-07-2011 06:19 AM

A used one has recently been put up on eBay:

http://cgi.ebay.co.uk/Novak-2cell-Li...item45fbe396be

kaszal 18-07-2011 06:36 AM

Thanks!

gainsy 18-07-2011 07:58 AM

Better look into this myself as i run a GTB speedo :o

VintageRacer 18-07-2011 08:05 AM

Quote:

Originally Posted by gainsy (Post 528131)
Better look into this myself as i run a GTB speedo :o

There are 2 versions. The later version has lipo cutoff built in. Not sure how you tell the difference from the ESC itself, but it is clearly printed on the box and it tells you how to enable/disable it in the instructions.

gainsy 18-07-2011 08:07 AM

Just checked my box, it's built in :)

VintageRacer 18-07-2011 08:19 AM

Quote:

Originally Posted by gainsy (Post 528134)
Just checked my box, it's built in :)

Good news. I'd still make sure it is on as you can disable it for when you are using NiMh.

gainsy 18-07-2011 08:23 AM

Have just asked for a instruction manual for it in the wanted section, didn't get 1 as i got it second hand on here, when i run the car it runs great then just stops so hopefully it is turned on
Thanks for the advice :thumbsup:

VintageRacer 18-07-2011 08:41 AM

You can download them from Novak

Installation instructions here:
http://www.teamnovak.com/download/in...lipoupdate.pdf


Profile programming here:
http://www.teamnovak.com/products/br...Prog.Sheet.pdf

gainsy 18-07-2011 08:59 AM

Cheers mate for the links :thumbsup::thumbsup::thumbsup:


All times are GMT. The time now is 02:03 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
oOple.com