oOple.com Forums

oOple.com Forums (http://www.oople.com/forums/index.php)
-   Tamiya (http://www.oople.com/forums/forumdisplay.php?f=22)
-   -   Turnbuckle Rob Ends (http://www.oople.com/forums/showthread.php?t=86932)

knighthawk 30-11-2011 08:18 PM

Turnbuckle Rob Ends
 
Stupid question and has prob been answered

My 511 rod ends keep coming off
which ones are recommended as a replacement

I see loads of 511/502's going round with white rod ends
What are they?

Thanks for any help
Dez

Donutt 30-11-2011 10:28 PM

I've used these for a couple of years.
http://www.jespares.com/electric-mod...tegory_id=1285

Replace all the front ones with these (one pack will do) and you'll never pop another balljoint again.

wildwillydriver 01-12-2011 11:13 AM

Quote:

Originally Posted by knighthawk (Post 589139)
Stupid question and has prob been answered

My 511 rod ends keep coming off
which ones are recommended as a replacement

I see loads of 511/502's going round with white rod ends
What are they?

Thanks for any help
Dez

White rod ends, can be the one below?

http://rclazy.com/shop/accessories/l...ural-losa6015/

Bye.
WWD
:)

mattybucks 01-12-2011 11:29 AM

You can use losi ball cups but you need to replace the ball joints. I now use the hardend tamiya ball joints with the grey tamiya ball cups.

bender 01-12-2011 04:09 PM

I had both a tamiya 501x and Durga and rather than replacing the rod ends i replaced the metal ball studs with the Kyosho ones off the Ultima/Lazer.

These seem a very tiny bit bigger and what it did was take out all the slop and stop the standard rod ends from popping off :D

Worked great, and cheaper than replacing both rode ends and ball studs, which you'll have to do if u switch over to Losi 4.3mm size


All times are GMT. The time now is 03:37 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
oOple.com