ZX-5 Undertray, do you use one?
 

Just wondering if anyone uses them?

I got one a while ago, but found I couldn't use velcro for the shell because it made the bottom of the shell too wide. Instead I left it using the holes, but at the weekend found it a complete pain putting the pins in.

I broke the undertray at the weekend anyway so now I'm going without this weekend.

I never used one, just put the velcro straight on the chassis edge and all will be good.

I got some velcro but it won't stick to the chassis! It comes off when I try to pull the shell off.

Looks like I'll have to glue it on.

Velcro....
 

I use schumacher velcro strips trimmed to fit and sticks so good - it has never pulled off once!
Hey presto no body clips and a sleek look :)
Hope that helps :)

You must have the Chassis side completely clean before putting the velcro on. Clean it with something light that will not attack the plastic Chassis, for example i use Revell Aqua Clean:

http://www.amazon.de/Revell-Aqua-Col.../dp/B004D2FLHI

I use contact cleaner ,just same as before u use servo tape to put your speedo in ,spray on wipe of and never shifting!

As above i use white spirit to clean the contact areas with.

I tried cleaning the air but I wonder if the velcro was crap.

Anyone, it's glued on now, so it's going nowhere

I always run an undertray but I use a bulldog shell so fits nice:thumbsup: