LRP SXX tc spec v2 switch wire snapped
 

I recently got a lrp sxx second hand. One of the switch wires have snapped. How can you make it so you can turn it on from plugging in the batteries?

Thanks

Sam

Remove the switch, solder the switch wires together, and insulate them.

If your good with a soldering iron. (I did this)

Open the case, cut the wires off, ans just bridge the two solder points.

-Or-

just join the wires, and put some heatshrink over them

or push the bottom of the switch and solder the wire back on 2 minuet job

Thanks for the replies guys!