As a fix for the dodgy nut holder u have several solutions that work
1. Put the nut in the holder then drip superglue in the nut end and let it set before rebuilding diff
2 use a tamiya nut and diff holder. (they are an exact fit!)
3. Use an associated diff screw and 1 piece nut/holder. This is also a perfect fit. The thread is not the same as losi which is why u need the screw as well.
The screw is a little longer so u get a more progressive adjustment range. However it is not too long that it impinges any driveshft travel in the outdrives
Number 3 IMO is the best fix. And a permanent one that is much cheaper than paying £10-15 for an alloy nut holder!!
__________________
proracing
Moss Models
Associated
Reedy
DJ KIRKY
|