Hello all,
I've just installed a new Hobbywing 120A V3.1 , wired up , and am unable to either get into set up mode or to set it up .
When holding the button down on the ESC the red light continually flashes and ESC beeps continuously , fist thing , is this right that it goes on continually ? or is something already wrong .
I don't have the set up box so am only setting up with the ESC itself .
So, assuming the above is correct , I'm pressing in neutral , holding at full speed , then press , full brake then press etc .
When I do this , the beeping and light stop , but the green light never lights and the set up does not complete .
Servo works fine and battery voltage from a 7.4v 5500 saddle is around 8.5 volts , motor is a Thunder Power 8.5 .
Any help appreciated
Peter