Hobbywing 120A 2.1 in a B4
Just looking for advice and suggestions.
I've recently acquired a Hobbywing 120A 2.1 for my B4, after running brushed for a while. And I've got an Inix 8.5T motor to go with it.
I've installed the Hobbywing into my B4, but with the Fan it definitely does not fit under the standard body, and with the fan removed it's still a tight fit.
What do peeps do in this situation, cut holes in the body, to allow the speedo to pop through, or something else.
Would be OK to run this motor/speedo combination without the fan, I will be running very little timing/turbo/boost as I am coming from a Reedy 19T brushed stock motor. Probably I will run the speedo in Blinky mode the first couple of times until I get used to it.
Any advice, thoughts, suggestions gratefully appreciated.
|