[Dkfream]

The shafts are not b44.2 shafts as the CVD kit for the 44.3 is 9947, plus the kit comes with front and rear shafts to replace the standard ones, I have tried fitting a b44.2 slipper assembly into my b44.3 and the front shaft is very slightly too long, they can't be b44.2 shafts as the motor assembly sits further forward in the car to allow rear motor fitment,

The only way is to buy the cvd kit 9947 to fit the shafts and then the slipper, I have even asked on AE wheelers on Facebook if anyone has modified the slipper clutch assembly to fit the standard shafts in the .3 but nobody has done it as the threaded part for the slipper adjustment would need to be cut off making it useless

Why AE don't design a b44.3 clutch as a direct fit on the standard shafts is beyond me, even with the new shafts it's not a quick swap at trackside unless you strip the shafts out, so either way your stuck with one or the other with no option to change mid race meeting ??????