Quote:
Originally Posted by Welshy40
Also can you do me one of your 3d belt tensioner and if so how much?
|
Thanks for the tip about the belt setup Welshy.
I am getting my 3D prints done on Shapeways at the moment. I am very pleased to see that you are interested in my belt tensioner design.
Below is the second revision of the design that I mounted on my buggy project. You will see that the bearings are now on the servo side (not on the battery side anymore), which gives more possibilities to adjust the lipo position.
I can share the design so you can review it and can get it printed on Shapeways if you are interested. It costs about 10 USD + delivery costs.
Cheers!
Ubi