My losi 22 is bit slow into entry / exit. it doesnt really understeer unless i pushed it too hard.
I am using savox 1251 with 150% travel on my DX2s
my setup is
Front Suspension
Toe: 0'
Ride Height: wishbones level
Camber: 1'
Castor:10'
Kick Angle: 25'
Oil: kit
Piston: 4 hole #55 pistons
Spring: red kit
Spindle Type: kit
Shock Limiters: 0mm
Shock Location: 2-middle
Bump Steer: 0mm
Camber Link: 0mm washers on tower, 0mm washers on hub
2mm spacer in front of castor.
Rear Suspension
Chassis Configuration: mid
Toe: 4'
Anti Squat: 1'
Roll Center: LRC
Ride Height: Driveshafts Level
Camber: -1'
Wheel Base: Medium
Oil: kit
Piston: #55
Spring: Yellow
Camber Link: 1-B (0mm under tower ball stud and 1mm under hub ballstud)
Shock Locations: 2-inside
50gram tlr rear weight.
Front tyres: staggers rib.
Rear Tyres: yellow mini pin - schumacher foam
I just purchased 0 degrees castor block, hopefully that helps.
It is not sharp like i seen like those asnmann X2C and others.
|