|
#1
|
||||
|
||||
speed passion esc stop working
Have just change resoldered my wires on esc now esc has stopped working any ideas why.
|
#2
|
|||
|
|||
Dry joint?
Some solder bridging across between two terminals? Too much heat frying the board? |
#3
|
||||
|
||||
As above, maybe first try getting some solder remover and cleaning it right back and starting over.
__________________
|
#4
|
||||
|
||||
did you remove ESC from car to replace wires ?
is it possible you have plugged RX lead back in wrong way round either in speedo end or rx end (i know i have )when refitting to car as above too much heat or bridging terminals may cause same issue hope it helps Fid |
#5
|
||||
|
||||
Thanks for all the advice had speedo checked out and i have fried it.
|
#6
|
||||
|
||||
Sorry to hear that. I currently have one being looked at and I suspect the same. Was working ok then suddenly started spewing smoke
__________________
I've got Araldite and a Swiss Army Knife - what more do I need? Yokomo YZ-2 No 4WD because nothing lives up to my original Optima. Until now maybe?... |
|
|