|
#1
|
|||
|
|||
New Front Pushrod Location
IMG_0118.jpg
If you were thinking of trying the different pushrods, I think this is a good way to do them. |
#2
|
||||
|
||||
very nice what is it that you have used, is it a servo mount?
|
#3
|
||||
|
||||
Looks like they are the ones for the 'stood up' servo mod... looks very neat!!
I must try this on my pred.. gave mine a run at Bury yesterday, bin messing about with a few things since looking over Kevs at the last worksop meet. have to say felt good.. I let Matty drive it for a good 5 mins too.... have to say watching it, it looked VERY good and was easily keeping up with mossys cat! |
#4
|
|||
|
|||
Yea they are the small servo mounts. I've sanded them down but I don't think you need to. Out of interest I think that the upright servo posts should be done in the next few weeks. I saw one and they are very neat!
|
#5
|
||||
|
||||
Quote:
For my 'stood up' servo mod i used two of the bits you have used for the push rod link and then 2 of the posts used to support the motor mount to the rear shock tower with a little filled of either end..but a custom part made for the job means less messing! |
|
|