Show us your B-MAX 2 - Page 6

dpackster1980 · #**101** 23-08-2013

Quote:

Originally Posted by blue_pinky

Yes! Should go quite easily depending how big your esc is!

I have an LRP SXX, saddles and a full size servo in mine and that receiver fits in no problem.

Exactly the same as I run and there's bags of room so you can make the wiring look neat.

JustARcFan · #**102** 25-08-2013

Here are mine

:

I'm going to use the car with the plastic chassis for low grip and the other one with alu chassis for high grip.

Didn't had the chance to test them both but there is a BIG difference in flex between the 2.

mes · #**103** 04-09-2013

My new Finnisher on the MR in rear motor configuration:

discothesnake · #**104** 04-09-2013

Is that a new shell from Jconcepts? The old version wasn't a good fit on the MR.

mes · #**105** 04-09-2013

No, that's the old one. It isn't a perfect fit due to the wider chassis, but still ok when only attached with velcro.

vandercarter · #**106** 24-09-2013

Quote:

Originally Posted by mes

No, that's the old one. It isn't a perfect fit due to the wider chassis, but still ok when only attached with velcro.

Can you put a pic of under the car?

Thanks.

mes · #**107** 24-09-2013

Unfortunately not at the moment, as it is already in mid-motor config for the indoor season. There's a little air between the shell and the chassis in the front, but not an excessive amount. I think it helps that I only use velcro and not the rear body post.

OneKiwi · #**108** 24-09-2013

I want this shell for the MR2

vandercarter · #**109** 24-09-2013

Quote:

Originally Posted by mes

Unfortunately not at the moment, as it is already in mid-motor config for the indoor season. There's a little air between the shell and the chassis in the front, but not an excessive amount. I think it helps that I only use velcro and not the rear body post.

Ok, thanks for the tip