|
#1
|
|||
|
|||
TM2 assembly questions
1)
Page 1: There is a "Copper Base" (part number TU0222) installed underneath the "Front Upper Suspension Arm Mount." It is too thick to allow the FUSAM to sit flush, causing the need to adjust the tension of the 4 screws used to mount the FUSAM so that it sits level. Was this the result of a design mistake? If it is for weight, there are better ways to do it so the FUSAM would sit flush (no gaps). 2) I assume gluing the edges of the carbon fiber bits is to help prevent delamination, What is the best method to do this cleanly? |
|
|