|
||
|
 |
|
||||||||||||||||||
|
#1
06-06-2011
|
|||
|
|||
Interference with Savox servo - any ideas please?
Has anybody had any problems from interference from Savox servos? When I operate the servo it causes the car to glitch and jump forwards. Originally thought it was because I coiled the long lead that they come supplied with, I shortened this and it still did it. Then I replaced my KO Esprit 2 40 meg radio gear with some Futaba 2.4 g and it still does it... Any ideas? Thinking of getting an Associated servo now. Speedo is LRP SXX.
|
|
#2
06-06-2011
|
||||
|
||||
|
low bec power add a power cap see if that helps
__________________
Mattys the driver,my names carl
|
|
#4
06-06-2011
|
||||
|
||||
|
yeh its just a capacitor with two wires solder to it that plugs in to + - of reciever ur servo is probably drawing high amps, also make sure servo end points are set so servo isnt stalling on full throw, as this will cause massive power drain
__________________
Mattys the driver,my names carl
|
|
#5
06-06-2011
|
|||
|
|||
|
my savox was doing this on sunday and it turned out to be my pt had a bad connection on the receiver
|
|
#6
06-06-2011
|
||||
|
||||
|
Some Pt's don't like being to near the Rx but thats interference not power loss
__________________
Mattys the driver,my names carl
|
 |
|
|
Linear Mode
