|
#1
|
||||
|
||||
LMR Wing on B44.1 fitting issues
Finally purchased a few LMR wings last week. Just cut them out and now in fitting mode!. C4.1 is easy but the B44.1 is proving tricky!
As the wings are thicker it's causing a problem with getting the clips through to secure it. I like to use the kit 9729 wing shims to create a angle on the wing, but using these prevent the wing from fitting. Apart from drilling the wing holders, are there any other solutions? Anyone else had this issue?
__________________
Vega RB6 - Orion - Apex Models - JE Models - Cable ties
|
#2
|
||||
|
||||
You could make some lexan washers to go underneath the wing? Or shave down the kit shims?
__________________
Schumacher Racing - Reedy - Schelle - TKR - Bandicoot Bodies - MIP - Nextlevelrc - Trishbits - Moss Models |
Thread Tools | |
Display Modes | |
|
|