Tapered pistons

[Dan Pickard]

Hi, is Nick Gurnell still making tapered pistons? Cant seem to get hold of him. If not does anyone know of anyone else who is making them at the moment? Thanks

[TonyM]

Durango tapered pistons - all with 1.0mm holes. Part numbers are:-


#TD330178 (4xholes), 330179 (5xholes) 330189 single taper(6xholes)

#TD330394 (4xholes), 330395 (5xholes) and 330396 dual taper (6xholes)

[Dan Pickard]

yes i know, i dont want the 6 hole pistons though, and i dont want to fill in the holes and drill them myself, but thanks.

[MiCk B.]

I've Ghea pistons.

Link: http://p-dubracing.co.uk/index.php?m...ha_filter_id=0

Small bore and big bore tapered pistons.

MiCk B. :-)

[Tomk26B4]

Have a look here Dan
http://www.oople.com/forums/showthread.php?t=119273

[nobby]

Sorry to highjack this thread, but couldn't see the point in starting another one.
I'm after some blank pistons.
Does anyone know where to get them?

[chet]

The Ghea are 6 hole though, the pro's only run 4 hole and have started to run 2 hole now.

[cornishboy176]

Originally Posted by nobby

Sorry to highjack this thread, but couldn't see the point in starting another one.
I'm after some blank pistons.
Does anyone know where to get them?

PM Gixxer on here

[TonyM]

Originally Posted by Dan Pickard

yes i know, i dont want the 6 hole pistons though, and i dont want to fill in the holes and drill them myself, but thanks.

OK, if you want 3 or less holes then as you say, they are not for you.

[Dan Pickard]

thanks tom