|
#1
|
||||
|
||||
Core UAC-40 help needed please !!!!!!!
Just getting used to my charger above.
Can someone please help me with the following two questions: -What is difference between charge function and fast charge function, and does it damage LIPO's in anyway or reduce life either one? -Storage mode how do you set it. I know how to get to it but it only goes to 1.0 as apposed to say my 5000 packs that i charge at 5.0. What should i be doing to make sure the LIPO stores correctly with this function. The instructions are pants tbh and im very keen not to naker my new LIPO's I run some 5000 50c and some 4200 35c for clarification. thanks in advance Russ |
#2
|
|||
|
|||
unless you are not planning on using your lipos for quite some time (several weeks), you shouldn't need to use storage mode. in-between meets (e.g. 1-2 weeks), lipos should be quite happy to sit there partially charged.
|
#3
|
||||
|
||||
it could be quite a few week hence the need for storage
|
#4
|
|||
|
|||
are you able to adjust the charge rate in Storage mode? I believe it just charges/discharges to a particular voltage...
|
#5
|
||||
|
||||
in storage it has the ability to change from 0.1 - 1.0
|
#6
|
|||
|
|||
when I did it, I just run through the storage mode after my regular lipo use and it was fine.
that was on a "clone" of the predecessor, UAC-30, mind you but suspect it's mostly the same software on-board... |
|
|