|
||
|
 |
|
||||||||||||||||||
|
#1
03-11-2012
|
|||
|
|||
Pillow balls vs Ball & bolt
Hi peeps.
Just noticed that Kyosho seem to chop n change in their Lazer series between dedicated Pillow balls (5.8mm x 2.6/3mm) and a 5.8mm ball with a bolt through the middle. Does anyone remember racing these and have any feedback with strength issues or maintentence?? You can just pop off the ball ends from the pillow balls. But did the fall off during racing? Which system was a later release by kyosho and which system is regarded to be better? Cheers guys Nick 
|
|
#2
10-11-2012
|
||||
|
||||
|
I prefer buying the associated tc ball joints and associated ball joints as they are a better product. Never liked the balls you screwed through as if it came lose caused problems.
__________________
www.kamtec.co.uk www.fibre-lyte.co.uk answer-rc.com/uk/en/ Answer UK team driver Designer of the Lazer ZX/ZXR carbon fibre tub chassis Designer of the Lazer ZXRS
|
|
#3
10-11-2012
|
|||
|
|||
|
Was trying to keep them original Kyosho.
Btw, posted your thrust sprung washers.
__________________
"If it hurts, it's probably worth it."
|
 |
|
|
Linear Mode
