|
#1
|
||||
|
||||
Schumacher pre glued tyers
Schumacher pre glued front tyres will they fit on a B4/X6
__________________
Fray Bentos |
#2
|
||||
|
||||
Yes!
These fit straight on to to the B4.. http://www.racing-cars.com/pp/Produc...rts/U6760.html MiCk B. :-)
__________________
http://www.dublinmodelracing.com/ (Off-road racing in Dublin) http://www.p-dubracing.co.uk (Stocking: 8Racing / AVID / GHEA / Xpert Racing / Factory R/C / Alton Design Innovations) http://www.msdmodels.ie/ (Trackside and on-line RC supplies.) |
#3
|
|||
|
|||
NB: if you are going to use Schumacher stagger ribs ya dont need to use an insert, but if you use the Schumacher cut staggers then you will need an insert,
but Pre-glued will come on rim unless you use Acetone to remove them from the Schumacher rims to fit them on Associated rims
__________________
LOSI SCT, Savox, InTech BR5 EVO, Ab Argus 52 www.bedworthRC.com www.cmcc-online.com www.ardentracing.com www.jcracingproducts.co.uk My Trader Feedback http://www.oople.com/forums/showthread.php?t=46608 |
#4
|
||||
|
||||
Quote:
__________________
Team Schumacher www.racing-cars.com Paint by www.customblitz.co.uk Feedback http://www.oople.com/forums/showthread.php?t=67178 |
#5
|
|||
|
|||
?
Can anyone confirm i can buy the above and they fit straight on a b4 please, without changing rims????
Otherwise I buy tyres and inserts and they glue on my b4 rims (after removing the old tyres)? Or alink to premounted tyres for b4 for indoor carpet please. |
#6
|
||||
|
||||
Quote:
Yes, What I've linked to above and the same in mini spike / pin (2wd type) will fit straight on to the B4. MiCk B. :-)
__________________
http://www.dublinmodelracing.com/ (Off-road racing in Dublin) http://www.p-dubracing.co.uk (Stocking: 8Racing / AVID / GHEA / Xpert Racing / Factory R/C / Alton Design Innovations) http://www.msdmodels.ie/ (Trackside and on-line RC supplies.) |
#7
|
||||
|
||||
Yes, the Cougar wheels are a direct fit front and rear.
You also get a choice of wheel widths for the front (slim and regular widths)
__________________
B-Max 2 MR
KEEP RIGHT ON BLUE IS BETTER |
#8
|
||||
|
||||
sure?
I tried to fit the bearings into the B4 wheels and were to tight.
__________________
XB4 & MORE , Team Xray, Team Gainsy Graphics, DPP Racing 2013 & 2014 OOPLE INVERNATIONAL BEER RACE RUNNER UP! FEEDBACK LINK =
|
#9
|
||||
|
||||
Quote:
MiCk B. :-)
__________________
http://www.dublinmodelracing.com/ (Off-road racing in Dublin) http://www.p-dubracing.co.uk (Stocking: 8Racing / AVID / GHEA / Xpert Racing / Factory R/C / Alton Design Innovations) http://www.msdmodels.ie/ (Trackside and on-line RC supplies.) |
#10
|
||||
|
||||
Quote:
I actually prefer the schumacher wheels to the associated ones.
__________________
B-Max 2 MR
KEEP RIGHT ON BLUE IS BETTER |
#11
|
|||
|
|||
tail end?
So cut staggers regular or slim on front?
Minipins rear? This is for 2wd on carpet. I went racing just after christmas and the fronts and rears say ballistic buggy on them. No grip at all on the rear. They came with the car (used) but dont look too worn. Part numbers for pre mounted tyres with inserts appreciated thanks. or part worns! |
#12
|
||||
|
||||
B4 or X6?
A lot depends on the track and setup
__________________
B-Max 2 MR
KEEP RIGHT ON BLUE IS BETTER |
#13
|
||||
|
||||
Definately mini pins (yellow) rear
__________________
B-Max 2 MR
KEEP RIGHT ON BLUE IS BETTER |
#14
|
||||
|
||||
yes
yellow mini pins rear and saggers front for carpet on 2wd, mini pins all round for 4wd...
But i did try some dboots, a little sliding but not bad, and thet do a softer compund than i tried so thay might work better. see what your local club guys run, thats the best advice, use what they use.
__________________
XB4 & MORE , Team Xray, Team Gainsy Graphics, DPP Racing 2013 & 2014 OOPLE INVERNATIONAL BEER RACE RUNNER UP! FEEDBACK LINK =
|
#15
|
|||
|
|||
I went to a club practice meeting, was running my b4. I did see staggers on other 2wd cars.
I would prefer to buy pre mounted wheels and tyres, is this also possible with rears? |
#16
|
||||
|
||||
YEP
ditto
__________________
XB4 & MORE , Team Xray, Team Gainsy Graphics, DPP Racing 2013 & 2014 OOPLE INVERNATIONAL BEER RACE RUNNER UP! FEEDBACK LINK =
Last edited by TARTMAN; 17-01-2012 at 11:00 PM. Reason: double as site went mad. |
#17
|
||||
|
||||
YEP
pre glued from many people, RClazy for one.
Why pre glued can i ask, its so easy to glue them, a few dabs of super glue on the inner rim and ya done. sure anyone a the local club will show you if ya worried. or theres vids on youtube of it. but eiher way. the guys at ya club will always help, I am sure of that, the RC crowd are a friendly bunch! well, they are at shrccc lol.....
__________________
XB4 & MORE , Team Xray, Team Gainsy Graphics, DPP Racing 2013 & 2014 OOPLE INVERNATIONAL BEER RACE RUNNER UP! FEEDBACK LINK =
|
#18
|
|||
|
|||
Hi,
is better to have regular width front wheels on a 2wd or the slim wheels?..could you use 4wd front wheels on the front of a 2wd? |
#19
|
||||
|
||||
no
4wd front different to 2wd front.
if using the staggers, slim front wheels are better, in my opinion.
__________________
XB4 & MORE , Team Xray, Team Gainsy Graphics, DPP Racing 2013 & 2014 OOPLE INVERNATIONAL BEER RACE RUNNER UP! FEEDBACK LINK =
|
|
|