|
|
#1
|
||||
|
||||
Setup for Astroturf tracks
Has any body got a baseline setup for a astroturf track like stotfold or baginton, that they could post.
__________________
Jonathan | Atomic-Carbon |
#2
|
||||
|
||||
probably better around but i like how mine goes
AE blue front springs 40wt oil kit piston shortest camber link KYOSHO #75 rear spring (yellow/green) 35wt kit piston camber link shortest on hub - middle on inside with 2 washers under. cells at the back, front one way
__________________
If your PM doesn't at first succeed - try, try again. I'll reply in the end, honest. |
#3
|
||||
|
||||
Thanks for that jimmy looks like a good setup to start with.
__________________
Jonathan | Atomic-Carbon |
#4
|
||||
|
||||
i will post what we run at stotfold after the weekend as we are trying a few things :wink:
__________________
Nathan Ralls HPI, Custom Blitz, www.piraterc.com mr-o foams woop woop racing officialy keeping team toe out inline |
#5
|
||||
|
||||
Hopefully see you down there Nathan
__________________
Jonathan | Atomic-Carbon |
#6
|
||||
|
||||
ok john as asked here is how i ran the car at stotfold, this is at a winter series with control tyres being shumacher green mini spikes
front toe in 1deg camberlink short camber 1deg 10 deg front hubs no shims under d pivot point, shocks, 40wt pistons drilled 2x 1.5 springs yellow la43 3mm removed no limiter shock mount middle hole at top wishbone on outer hole, rear la232 universal swing shaft camberlink short on the inside middle on the outside with no washer kit hole on hub but using hub number SPW123 same hub but in alloy toe-in block a25 no 3 shim under front pivot block for anti squat kit sway bar shocks 30wt oil 2x 1.5 drilled pistons blue springs additional notes 76 spur gear 17 pinion 10x2 wing mounted central holes with max angle,full gurney flap la43 is the bottom shock ball joint used on the front ball joint to create more droop we cut approx 3mm off of this so the car bottoms out before the shock does weights 30gms on the chassis by the motor and 15 gms on the servo cells in rear position ride height drive shafts level hope this helps nathan
__________________
Nathan Ralls HPI, Custom Blitz, www.piraterc.com mr-o foams woop woop racing officialy keeping team toe out inline |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
What setup for dirt tracks? | zagonielod | Ansmann Racing | 1 | 08-07-2010 08:31 PM |
Cat SX/SX2 setup change frequency | /tobys | Schumacher | 15 | 07-04-2010 10:21 PM |
B4 Setup On Grass And Astro Tracks | sam15 | Team Associated | 0 | 19-06-2009 10:24 AM |
1/10th & 1/8th HUDY setup Stations & tire truer | carlin | For Sale | 0 | 21-05-2009 07:46 PM |
X-6 Setup help for a Bumpy Grass Track | cutting edge | X-Factory | 13 | 18-02-2007 04:50 PM |