Brushless for the X-6

[stegger]

What brushless speedo's fit the X-6 ? I've tried the Losi and the speed passion GT and neither of them fit unless somebody has come up with an answer ? I don't want to DREMEL the chassis So is it the LRP or NOSRAM speedo's the only ones that fit without any mods ?

[David Church]

Mine has been dremeled so a Novak wil fit, no problem

[Gnarly Old Dog]

The Nosram / LRP will fit without any mods but if you want to install it so it sits square in the chassis (a la Racer's Review Car), you'll need to dremel approx 6mm off of the top of the chassis mould ejector pin feature - the little half circular bump that protrudes into the ESC pod.

5 minutes with a dremel and a suitable milling bit - easy peasy - and taking only a small amount from the top of the mould feature isn't likely to reduce the integrity of the chassis in any way.
But like I say - you don't need to do it if you don't mind the ESC not sitting square in the pod.

[Dunc]

A Tekin R1 or RS will fit nicely with room to spare

[josh_smaxx]

I managed to get the GTB in, but only just, its squeezed in and the velcro isnt holding it a huge amount. Has never fallen out though

[janus_77]

If using a NIMH setup http://2wdrc.com/tech/GTB.htm

If your using Lipo you can also place the GTB in the middle (where the 2 cells used to be)