|
|
#2
|
||||
|
||||
Team Losi Setup data base - Electic Off Road
4x2: Triple X CR Triple X BK2 Triple X 4x4: Triple X4 Double X4 & WE Truck: Triple XT-CR Triple XT Jimmy, if not a appropriate, remove the reply! jimmy: no mate, thats a cool resource, thank you. Last edited by Arn0; 11-09-2009 at 10:03 PM. Reason: Fixing link issue |
#3
|
|||
|
|||
Here is my XXXCR setup from last weeks regional at Batley:
Front Toe - 0 Ride Height – Chassis Level With Rear Camber - -1 Caster - Std Sway Bar - None Oil - 35 Piston - Orange Spring - Blue Limiters - None Spindle Location - Low Steering Ackerman – Rack Bump Steer - 0 Camber Link - 2B Shock Location - 4 Middle VLA – Long Front Wing - Yes Notes - 15gramms in bulkhead Rear Toe-In - 3 inboard Pivot Support - Std Rear Hub Spacing – Middle Driveshafts/Outdrives – Steel Dogbones/Steel Outdrives Ride Height - Driveshafts just below Level Sway Bar - None Oil - 35 Piston - Red Spring - Yellow Limiters - Inside 0 - Outside 0 Camber Link – 2E 4 gold washers under the ball stud Shock Location - 2 Middle VLA - Short Wing Position - Low Battery Position - Forward If you need anything else just ask Last edited by Cockerill; 16-11-2006 at 11:59 PM. |
#4
|
|||
|
|||
Cheers Tom much appreciated! will give this setup a try at york next saturday.
Craig Collinson |
#5
|
||||
|
||||
XXXCR
I have been trying a few differant things on my xxxcr, one is flipping the rear pivot block. Has anyone else tried this? How did they find it?
I am still looking for a nice generic set up, something I will try at Kidderminster on Sunday? |
#6
|
||||
|
||||
Quote:
Have a look here http://www.helgerracing.com/eknowled...eframeset.html and go to the losi setup page and try the setups for stotfold.
__________________
Xray, Orca, 1UP Racing, Avid, X Factory UK, RC Disco, Hudy, RichPaint, RDT products, Screwz4rc http://www.screwz4rc.co.uk My Trader Feedback - http://www.oople.com/forums/showthre...hlight=tyreman
|
#7
|
||||
|
||||
we broke one a couple of weeks ago and found that the xx4 ones fit nps and seem to be same angles etc hole slightly bigger but if your out of the xxxcr ones they worked OK
__________________
Mattys the driver,my names carl
|
#8
|
||||
|
||||
Quote:
|
#9
|
|||
|
|||
Hello I need help whit a start setup for super super high grip carpet track. Whit not soo many jumps. We have to yous Losi Taper Pin for rear and tier trackrion if we whant.
Niclas M from Sweden |
#10
|
||||
|
||||
May i ask what car you have???????
A
__________________
Ashley Williams I always thought by 2013 we would have flying cars, but we have got blankets with sleeves! |
#11
|
|||
|
|||
I have a XXX CR
|
#12
|
||||
|
||||
ant help you with that hadnt any personal exsperiance of it still waiting for mine.
If i remeber correctly Tom Cockerill posted his indoor setup up earlier in the thread have a look though im sure there is a good one there that you can tweak slightly to suit your track. A
__________________
Ashley Williams I always thought by 2013 we would have flying cars, but we have got blankets with sleeves! |
#13
|
||||
|
||||
May that be considered as a valuable replacement of RCsetups?
Triple X-CR Second post in page 1 give some more pages like this one! RcNille - You may find what you are looking for with this link. |
#14
|
|||
|
|||
Does anyone have the setup for the prototype xxx-cr (the hybride) beside doughtys setup that I've already seen?
|
#15
|
||||
|
||||
Does anyone have a set up for the cactus classic
Thanks
__________________
Losi 8T, X-5 AE FTTC5, RC8, T4, B4, B44 |
#16
|
||||
|
||||
Check post#92, there is a setup @ SRS Scottdale
|
#17
|
||||
|
||||
__________________
Ashley Williams I always thought by 2013 we would have flying cars, but we have got blankets with sleeves! |
#18
|
||||
|
||||
I'm searching setups for XX4 and XXX-CR for following conditions:
bumpy track and loose surface (hard clay with layer of dust over it)? Bit rutted after practices of 1:8ths. Carpets on jumps and also in some corners. Thank you
__________________
Retired from racing
| パベルともうします、よろしくおねがいしますスロバキア人だ、今イギリスにすんでいます。| | Ralls Racing | RCSGraphicWorx - paints, paintjobs, decals, custom wear | Schumacher Racing | Mr.O inserts | |
#19
|
|||
|
|||
I've got a good lightweight/lipo setup for basicly the same conditions. The Car weigh just below 1500grams, 10g above minimum
|
#20
|
||||
|
||||
Hi Ottoswe,
I've just converted to lipo, so I would be very interested in this setup, could you post on here? Thanks
__________________
Ian Dalziel
Trader Feedback North East Amateur Motorsport (formerly Jarrow & Oxclose RC Racing) http://www.neamRC.co.uk Racing Sundays 6pm-10pm @ Seaham Youth Centre, SR7 8QE |
|
|