more problems.

[Nigel]

well im starting to have second thoughts on my purchase on this buggy. because i seem to have problem after problem now

problem 1: my diff's are really smooth but when i put the diff's drive shafts into the slipper/spur assembly and try to spin it i feel a lot of friction. too much to be normal.

so i took out the diff's and just put my spur/slipper assembly onto its mount that it sits on when its in the buggy and when i spun it i felt a lot of friction. so this is my problem with the too much friction.

has anyone else had this problem? if so how do you fix it or dose it go away after a couple of runs?

problem 2: my front diff seems to be losing a lot of its diff fluid ad my rear has lost a bit and i have not even run my buggy yet. i even followed all the diff building instructions online perfectly. is there any seals i can use to fix this problem? i have seen threads about this before. but i have not even run my buggy yet so im wondering if something else is wrong with my diffs.

problem 3: on my spur/slipper assembly the side that is longer seems to be crooked. i noticed this when i put the diff drive shafts in and spun it. because the whole shaft started to wobble. im not really sure what the heck is wrong here since i assembled it all correctly (at least i think i did.)




not really a problem but dose anyone use these little round plastic piece's that go over the end of the drive shaft because i had a hard time putting them on but when i got them on they kept popping off.