|
#1
|
|||
|
|||
Dex210 ball cup size
I have broken 2 ball studs recently. I think they are a little thin walled where the hex driver goes. I was able to salvage a shorter one from my dex410r to finish my day. Lundsford sells m4.8x10mm. I know the 10mm is right; will the m4.8 work with the stock durango ball cups? I have a 22 and tired a ball stud in the durango ball cup.. Did not work. I tried googling for my answer but gave up after awhile..
Thanks |
#2
|
||||
|
||||
There is a big thread about this as lots of people swapped them out.
Original is 4.7mm |
#3
|
|||
|
|||
Thanks I was in a bind and looking for a quick fix. I did change my 410r to the Losi ones. I could not find a 10mm local.
Thanks
__________________
DEX410r DEX210 HOTROD HOBBIES HAMITON ONTARIO CANADA |
#4
|
|||
|
|||
HPI86196 anyone tried these ball studs?
I broke a stock one the other day and thinking of replacing the whole lot. Cant decide between these or the Losi ones (the Losi ones are 1mm higher correct?). |
#5
|
||||
|
||||
Schumacher U3497 long ball studs and Losi extra rigid ball cups LOSA6016 are the way to go!
__________________
Chris TeamC TM2, TC02EVO & TM4 Abisima, Savox and Orion Lazer ZX5-FS2, Rudebits DB1, Powered by Orion R10 and all Steered by Savox (and blind luck!). KoPropo EX10 Kyosho MP9 , OS Speed Paint by Magoo |
#6
|
||||
|
||||
Lunsford also has them for the 210
__________________
Team Durango DEX210 Mrcz zeeland, the only off-road club in the whole of zeeland, the Netherlands |
Thread Tools | |
Display Modes | |
|
|