|
#1
|
|||
|
|||
ORCA MOTOR WIRES
Hello
has anyone tried to change the motor wires using the software option in the setting box. I get the setting ok then press send and the display just stays on Sending. Any ideas would be useful I have a motor A B C left to right as the same on the speed controller per the normal way Neale |
#2
|
||||
|
||||
It works, I ran my car C-B-A with that setting.
Select either, press Enter to go to the send menu and press Enter again. Switch off, pull the setup box out and try the throttle (gently), you will know if it works or not, a gentle short throttle action is fine if ever the setting was not applied. |
#3
|
|||
|
|||
Hello
found the problem wrong software installed Neale |
Thread Tools | |
Display Modes | |
|
|