|
#1
|
|||
|
|||
HELP needed on weight in my x6
dear racers
im currunly runnin x6 n have been using lead strips n some weight in bulkhead just wounding what total weight u guys use n where abouts u put it on the car cause at min cant get it right so plz help from wackyracer |
#2
|
||||
|
||||
Most set-ups are pretty specific about the amount of weight and its placement. There is much discussion in this thread about it. To begin with, where do you race? It's quite different for different circumstances. Here in the U.S. on most dirt tracks, you want total weight between 1550 and 1650 gr. In U.K. on grass/astro, it's about 100 g more.
|
#3
|
|||
|
|||
i race in the uk n where is it best to palce the weight
|
#4
|
|||
|
|||
Most of the team here in the UK use the "Rudebits" weight kit. It is by far the set that offers the most options and diversity of any of the weight kits out there and is an extremly well made piece of kit.
As a general rule, on almost all grass and astro tracks we nearly always use the two under LIPO weights and the under speedo weight in the centre areas of the car. The ones we "tune" or play with most are the servo weights (4 stackable 30g weights - resulting in 120g max) and these fit directly behind the servo. Depending on the track and conditons we run anyhwere from 1 (30g) to all four (120g) of the weights in this area. The only other area of the car that is covered is the two "rear pods" and when it is wet and slippery we add the corner weights into these two areas and typically will remove "some" or "all" from behind the servo, depeneding on the driver, track, tyres and track conditions at the time etc to suit personal taste.
__________________
ORCA - LC RACING - RUDDOG PRODUCTS - JCONCEPTS - ALPHA PLUS - TEKIN RACING - ULTRAPOWER AVID R/C - VAMPIRE RACING - EXOTEK RACING - LUNSFORD RACING - X-FACTORY - TUNING HAUS - WTF AME - RAGE R/C - REVOLUTION DESIGN RACING PRODUCTS - McKUNE DESIGN - TEAM AZARASHI X-PARTZ - PHAT BODIES - RACERS EDGE - RM2 - DIRT RACING PRODUCTS - DMS INSERTZ TKR GRAPHICS - BF MATERIALS - BATAN - DMS PARTZ - TEAM AJ Tel : (01923) 816636
|
|
|