|
#1
|
|||
|
|||
blades for Corally RDX - help required
Hi,
I need some blades (drive shaft caps) for Corally RDX (think HMX has same driveshafts so assume will fit these aswel) Anyone know what (if any) other brands/sizes will fit? thanks |
#2
|
||||
|
||||
Sorry if this is a little late... I've had the same problem with my Phi Touring car, up until now I've been shaving & trimming down an old stock of RCLab blades, but with this stash likely to run out soon I started looking out for alternatives.
The best I've found so far is the blades for the ARC R10 - they do need to be shaved down in thickness to 3mm (unless you open up the slot in the outdrives) & trim a little off each end using a scalpel. They seem to be more durable than the original Corally items & the RCLab parts I was using too, so all is
__________________
TeamC TM2 (V1) Xray T4 15' (I finally conformed!) Associated R5.1 1/12th Pan Car (Occasional Racer) + too many vintage racers to list! |
#3
|
||||
|
||||
Tamiya black blades are 3mm, the white ones are 3.5mm
__________________
http://www.thercracer.com/ |
|
|