|
#1
|
|||
|
|||
Couple TM2 V2 questions
1: what is the center CVD pin size and are they able to be pressed out? (mine are worn)
2: anyone know a source for the insert set for the rear? Inside line does not list them.
__________________
PR Racing UK Absima UK |
#2
|
|||
|
|||
the pin is 2.5mm yes you can press them out but its HARD.
|
#3
|
||||
|
||||
2: anyone know a source for the insert set for the rear? Inside line does not list them.[/QUOTE]
Kev will be able to get them for you, just ask him. The part number you want is T04139
__________________
Facebook : Lyons-RC / Twitter : @lyonsrc1 / Instagram : lyonsrc1 |
#4
|
||||
|
||||
If that's what you are after then Kev does list them:
http://www.insidelinemodels.com/insi..._category_id=0
__________________
Clive Check out the goings on at HBI here: https://www.facebook.com/pages/Heske...68872353145927 |
#5
|
|||
|
|||
Yeah I found the set under the TM4 section. Thanks guys!
__________________
PR Racing UK Absima UK |
|
|