|
#1
|
||||
|
||||
How to mount ABS shells?
Anyone give me some pointers to get the shell mounted to the car.
I don't want to cock the job up, so any help would be appreciated. I'm thinking of using 4off vertical worlds body posts to mount an abs escort shell. I understand how to do it with clear lexan, but opaque abs i have no idea what to do. Thanks |
#2
|
|||
|
|||
Personally I use a chalk pen. Put some liquid chalk (or any ink) on the tops of the posts, lower the shell into position and the holes are marked, I measure to check they are all even before drilling.
May not be the ‘correct’ way, but works every time for me. Also there is a tool for this that works on similar principle… http://www.ebay.co.uk/itm/Body-Shell...item3a6823da4b |
#3
|
||||
|
||||
ihave used similar tool to good effect on painted lexan
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#4
|
||||
|
||||
When i ran mardave i used to put a blob of blu-tak on each post top then push shell on. Then when you take shell off again the blu-tak remains inside giving you and indent to drill.
|
#5
|
||||
|
||||
Thanks!!
|
|
|