Slipper shaft not true ?

[WHITTLER555]

Hi, I have sent mine back to Adam for him to check out, I will report back to you and make sure its not builder error!

[passy]

another one not running true here either - shame as I don't have an old one to swap it out with.

[WHITTLER555]

Passy and AndyS - please contact your relative Team Durango importer and speak directly with them, I am sure they will help you out.

[MikePimlott]

Did any body find a cure for this ?

[steel]

yer i would also be interested to find out about this tryed all sorts with mine but still the same

[passy]

For those that have an old version that is true can you work out what part is at fault in the V3 kit?

spring, slipper plate or .....

Many thanks.

[Northy]

If you really think you have a faulty part contact TD

support@team-durango.com

They are a friendly bunch

[muratti]

Any news on this topic? Mine runs untrue too

[snook]

have the 2010 spec car. the slipperplatething is "untrue" since assembly.
i have a spare slipperplatething and i have a spare spurgear.
however i never switched to the spares because it was never a problem.
yes the spur slightly disintegrated after the first 2 runs (there were tiny spurgear flakes all over the inside of the body...)
BUT it still runs just fine, and the mesh was never better.
id just get a spare spur incase anything happens, but would not worry about it.