Team Tekin Q&A

[mattJT]

.....deleted......sorted

[DCM]

Originally Posted by kyfran95220

so...
Firmware : 2.12
Boost : 15 - Start RPM 5443 -> end 20016
Motor type : Fw/Bk
Volt. cutoff : 2S
Drive : Sensored
Throttle prof. : 3
Current limiter : Off
DB : 15
Mini Bk : 8
Mini Throttle : 8
Bk Strength : 90
Neutral width : 13

My radio is a Robitronic TL3C
Car : Yokomo B-max (84/19)
motor : SP V3 - 6.5t

an idea ?

Couple of things, any reason your running in Sensored mode?? car must be really hard to drive in that mode?

How many LED's are showing on the temperature indicator?

[wackyracer]

grass n astro turf tracks how is it best to set a rs pro uo with hotwire on 6.5 reply thanks craig

[Big G]

The temp lights that flash on the speedo after a run.

Are they referring to the speedo temp or the motor?

Mine are usually 4 after a 5 min run + a couple of warmup laps and 6 lights when we did a 7 min final. Indoors, small track, 7.5 motor.

[DCM]

Thats the ESC temps

[Big G]

ok cool. I guess my speedo is doing good on temps

[DCM]

Originally Posted by wackyracer

grass n astro turf tracks how is it best to set a rs pro uo with hotwire on 6.5 reply thanks craig

Dual Mode
Timing at 80
keep the rpm range as standard
Neutral Width 8
Throttle Profile 3
Limiter at 80-90%

[Randy p]

Yup, 4 and 5 led's is fine.

[cr1tch]

i have just got a Rs pro for my Losi 22, what set ups would you guys recommend, im running a Novak ballistic 10.5! what setting should i go for? should i run turbo? and how do i identify the temp light as i have not got instructions. any other info would be really helpful.... as some touring car drivers i race with say it like trying to drive with an on/off switch.... Last speedo was a Speed passion GT 2.0

Thanks

[mattJT]

Originally Posted by cr1tch

i have just got a Rs pro for my Losi 22, what set ups would you guys recommend, im running a Novak ballistic 10.5! what setting should i go for? should i run turbo? and how do i identify the temp light as i have not got instructions. any other info would be really helpful.... as some touring car drivers i race with say it like trying to drive with an on/off switch.... Last speedo was a Speed passion GT 2.0

Thanks

Bottom right is the manual and the team driver set up sheets

http://www.teamtekin.com/rs.html

[DCM]

Originally Posted by cr1tch

i have just got a Rs pro for my Losi 22, what set ups would you guys recommend, im running a Novak ballistic 10.5! what setting should i go for? should i run turbo? and how do i identify the temp light as i have not got instructions. any other info would be really helpful.... as some touring car drivers i race with say it like trying to drive with an on/off switch.... Last speedo was a Speed passion GT 2.0

Thanks

What size track, track surface, as that will determine if dual or sensored mode is better.

[wackyracer]

Hello racers I have x6 n a 22 need a gd setup on both Tekin rs n pro n wot gearing motors r x12 6.5 n x12 13.5 wot wud u lot suggest Thanks craig on astro turf track

[DCM]

6,5, use the dual mode I posted above, for 13.5, check on the team setups on the Tekin Website.

[cr1tch]

Originally Posted by DCM

What size track, track surface, as that will determine if dual or sensored mode is better.

been mainly running at southport, on astro and the track is quite large also will do so indoor carpet meetings a agian a quite large track. would use surggest that i use a fan as the losi 22 has little or no air flow....

[HarlowS]

You wont need a fan in a 2wd, we are running them in 4wd Durango's without a fan and all is fine

[DCM]

Originally Posted by cr1tch

been mainly running at southport, on astro and the track is quite large also will do so indoor carpet meetings a agian a quite large track. would use surggest that i use a fan as the losi 22 has little or no air flow....

I don't run a fan in my 22 running a 10.5 and it barely registers any internal heat.

Mines a small track so I run it in dual mode, but if it is a big track, 10.5 you may want to run it in Sensored if you find Dual mode a little soft.

[CODMAN]

Hey guys, I just picked up a redline 7.5T motor and can't find anywhere info on the stock timing setting of the motor endbell. I can see the graduations on the can (degrees), but don't know the reference point used to read the setting (is it the little groove in the plastic endbell?).

Just trying get the right info before I start playing with internal settings in the ESC.

Cheers!

[DCM]

there should be a gradient on the can and a 'pip' on the plastic moulding, if your not sure, slacken of a little the three countersunk screws, twist clockwise till it stops, thats 0', twist it anti-clockwise, thats 24', in the middle is 12' which is stock setting for a Redline.

[CODMAN]

Thanks so much! Exactly what I wanted to know.

Cheers!

Originally Posted by DCM

there should be a gradient on the can and a 'pip' on the plastic moulding, if your not sure, slacken of a little the three countersunk screws, twist clockwise till it stops, thats 0', twist it anti-clockwise, thats 24', in the middle is 12' which is stock setting for a Redline.

[CODMAN]

I can,t find any suggested gearing on the Tekin website. i'm going to be running 4WD Buggy (Yokomo Bmax4) with a 7.5T in it. What final drive ratio would you guys suggest for a starting point with no added timing? I'm going to be running on dirt, so obviously I will only take that as a starting point and will check temperature as I go along. But I need a starting point for my trials...

Thanks for any input on this!