|
#1
|
||||
|
||||
EA3 REAR ARMS
I got a set of this in a job lot for a xx4
Are they stronger than the standard plastic and graphite ones? Also, would they be any good on a 2wd xx as they have holes that would make it the car wider at the rear than standard cheers liam |
#2
|
||||
|
||||
Ref xx4, i think you'll need the hubs else the width will be wrong, as with the xx. You can't just make it wider as the driveshafts will come out of the diff.
__________________
Nortech is ACE! |
#3
|
||||
|
||||
good point!
its prob not worth bothering with then cheers |
#4
|
||||
|
||||
They are not as strong as the plastic and graphite parts.
You can use them with the outside holes and keep the stock width. If you use the inside holes your car will become narrower than stock. |
#5
|
||||
|
||||
I see thanks.
Maybe its worth boiling these plastic parts? |
#6
|
||||
|
||||
Took some time to find this old post but I measured it all before. have a read about 1/2 way down.
http://www.oople.com/forums/showthre...t=18908&page=3
__________________
Nortech is ACE! |
#7
|
||||
|
||||
I think boiling only works for Nylon based parts, I'm not sure about the Losi materials.
Anyway, the rear arms almost never break, regardles of the material, so I wouldn't worry about it. |
|
|