|
#1
|
|||
|
|||
mad monkey slipper
hi guys,
this will sound really stupid but im new to off road and ive come upto assembling my slipper clutch, and i really havent got a clue about how tight to tighten it any help would be greatly appreciated thanks |
#2
|
||||
|
||||
Just tighten the nut on the end of the shaft
__________________
Team Associated B44FT ~ LRP SXX TC Spec ~ LRP Vector X12 6.5t ~ Savox SC-1251MG ~ Spektrum DX3S Schumacher Cougar SV Pro ~ LRP Sphere TC Spec ~ Losi Xcelorin 6.5t ~ Savox SC-1257 ~ Spektrum SR3100 ~ Spektrum DX3S In progress: Team Durango DEX410 V1-V4 hybrid ~ DESC410V2 ~ DEX210 |
#3
|
||||
|
||||
Have you tried setting it as the manual says? (18mm from slipper plate to the top of the adjuster nut) and seeing if that works?
__________________
oOple Trader Feedback: http://www.oople.com/forums/showthread.php?t=54309
|
#4
|
||||
|
||||
I found the best way to set mine was to undo the nut to near the end, then place the buggy rear wheels between my legs with the cars front pointing to the floor, then press the throttle and gradually tighten the slipper until the buggy goes to nearly half way then drops back down.
This is my way anyway, and i've not stripped any gears in about 7 hours of driving. |
#5
|
|||
|
|||
hi guys
thanks for all your help, ill certainly try out your method if the kit setting doesnt do the trick im just waiting for my new wires come now and its ready to go! |
|
|