|
#1
|
||||
|
||||
reedy lipo in b4
Can some one tell me please how you fit a reedy 5000 lipo pack into a b4
The battery strap will not go under the tower .
__________________
Team Associated- HobbyWing- Reedy- CML |
#2
|
||||
|
||||
|
#3
|
||||
|
||||
nah it dont
__________________
Team Associated- HobbyWing- Reedy- CML |
#4
|
||||
|
||||
it will fit if you have the carbon brace................
failing that and if you add lead sheets...you need to dremel the bottom of the tower away and add a small sheet of carbon above the tower to strenghen the area. this will give you enough clearance to run it with a standard brace. another more simple way of acheiving it is use a strip of lexan and just mount it accross the two clip pins. this holds it it, but can jump up and down at the rear a little. Lee
__________________
Tamiya ~ Mugen Seiki ~ Viper RC ~ Pro-Line ~ Xpert Servos ~ BEAT ~ Protek RC ~ Amain Hobbies ~ LMR ~ Ultimate Racing ~ Nitrolux ~ Nibbo Designs ~ Stickit1 Racing ~ The World Famous TFR! |
#5
|
|||
|
|||
I just put the strap in the bottom triangle of the shock tower and take up any slack with a small piece of foam between the lipo and the battery strap - works perfectly .
|
#6
|
||||
|
||||
I thought as much with the tower,I shaved a little off the tower and the plastic brace last night but stoped and thougth i best ask if this is right befor i naff up my new car
__________________
Team Associated- HobbyWing- Reedy- CML |
#7
|
||||
|
||||
Milzy, I never had a problem at all it just slotted in, I just ran the pack upside down so the flat side was at the bottom of the chassis.
don't remove the hard casing like I did to fit in the TC as it goes bang
__________________
|
#8
|
||||
|
||||
haha you nut
__________________
Team Associated- HobbyWing- Reedy- CML |
|
|