|
||
|
 |
|
||||||||||||||||||
|
#2
23-01-2010
|
|||
|
|||
Looks promising... one thing i would say is you need to "centralise" the turnbuckle...
Make a small traingular shape from CF or similar and mount that to the gearbox where the motor guard was, then with the a hole in the middle of the two holes mount the turnbuckle to that and then the middle of the chassis... if that makes sense?? Good work though 
__________________
Team Losi Racing, Horizon Hobby TLR 22 5.0, TLR 22X-4, TLR 22-4, 22-4 2.0 Atomic Carbon S2, S44, Vega B4.1 Trader feedback: http://www.oople.com/forums/showthread.php?t=19374 
|
|
#3
23-01-2010
|
|||
|
|||
|
it makes sence its off at an angle to clear my lipo, mainly because i could do with some threaded bar from b&q so i have a link long enough
it also stops twisting of the t plate as the motor plate is secured to the chassis, this helps to blance things out the problem i have is the whole truck is very bendy and the plastic isnt very rigid some obviosuly i expected some flex but this gets ixed with the inherent bendyness making problems bigger this is v1.0 version 2 will come when i see what breaks and why
__________________
If it doesnt make sence alas i am pissed...
|
|
#4
23-01-2010
|
|||
|
|||
|
I was thinking that may be the reason for the offset when i looked closer and noticed the motor plate attached to the chassis...
You could run some "raised" CF supports down the sides of the cassis...? that helps to reduce flex, i did it on a custom B4 i made a while ago... Kind of like this... http://www.oople.com/forums/showthread.php?t=19564
__________________
Team Losi Racing, Horizon Hobby TLR 22 5.0, TLR 22X-4, TLR 22-4, 22-4 2.0 Atomic Carbon S2, S44, Vega B4.1 Trader feedback: http://www.oople.com/forums/showthread.php?t=19374
|
|
#5
23-01-2010
|
|||
|
|||
|
I LIKE THAT !!!
cheers will look in to it could also run a CF plate across the origional battery posts and secure it so the rod could be mounted centrally also the two plates coming from the gearbox to the chassis where do they mount to ?
__________________
If it doesnt make sence alas i am pissed...
|
|
#6
23-01-2010
|
|||
|
|||
|
Quote:
Not too sure which 2 plates you mean??? The ones that are mounted to the rear shock tower??
__________________
Team Losi Racing, Horizon Hobby TLR 22 5.0, TLR 22X-4, TLR 22-4, 22-4 2.0 Atomic Carbon S2, S44, Vega B4.1 Trader feedback: http://www.oople.com/forums/showthread.php?t=19374
|
|
#9
31-01-2010
|
|||
|
|||
|
i need to redo
all the angles neeed rofining and measurements making but the mod is east nothing is requires except a dremel and some tie roda tested it the otherday and the handling is very different loads more steering but the rear end loses some consistency  still fun to do and changes things on the cheap
__________________
If it doesnt make sence alas i am pissed...
|
 |
|
|
Linear Mode
