|
||
|
 |
|
||||||||||||||||||
|
#1
18-02-2010
|
||||
|
||||
Handmade CR2 Project
hi all
i desided to make my own cr2 for a bit of a chalinge. i had a xxx-cr and an old spair chassie. i had to dremal the back of the chassie out and put nuts and bolts through the back to hold the rear plate on. for the rear holes in the plate i got anouther rear plate and layed it ontop the other way round and lined up the 4 outside holes. i still need to put a brace to stop the rear flexing but its not bad for a 13 year olds work(with no help so far) DSC00036.JPG DSC00034.JPG DSC00064.JPG DSC00063.JPG DSC00068.JPG DSC00067.JPG
__________________
 FOR ALL YOUR NAME TAG - RC CAR DECALS - RACEWEAR
|
|
#3
18-02-2010
|
||||
|
||||
|
Good job
|
|
#5
18-02-2010
|
|||
|
|||
|
Good job so far! Just make sure you have a spare t piece predrilled... I did something similar and the extra holes make the t piece quite weak... As for the bracing try putting a post eother side of the battery tray about half way down the chassis, then use two turnbuckles up to the two hole on the gear box.. Hope that helps
__________________
Team Losi Racing, Horizon Hobby TLR 22 5.0, TLR 22X-4, TLR 22-4, 22-4 2.0 Atomic Carbon S2, S44, Vega B4.1 Trader feedback: http://www.oople.com/forums/showthread.php?t=19374
|
 |
|
|
Linear Mode
